- D-link DCS-900 Internet Camera ManualVersion 1.10
Table Of Contents
- Table of Contents
- Package Contents
- System Requirements
- Introduction
- Features and Benefits
- Connections
- LEDs
- Hardware Installation
- Security
- Using the Setup Wizard
- DCS-900 Configuration
- IPView Lite Application Installation
- IPView Lite - Getting Started
- Uninstall IPView Application
- Appendix A: Frequently Asked Questions
- Troubleshooting
- Appendix B: How to PING your IP address
- Time Zone Table
- Xplug Control Installation
- Adjusting the Camera Focus
- Technical Specifications
- Contacting Technical Support
- Warranty and Registration
8
LEDS
LED stands for Light-Emitting Diode.
Power LED
The Power LED is positioned on the right side of the DCS-900 lens. Steady green confirms
that the DCS-900 is powered ON.
Note:
There are three settings for the Power LED for monitoring purposes: Normal / Off /
Dummy. Please refer to the DCS-900 Camera Configuration section for detailed
information and usage.
LAN LED
The LAN LED is positioned on the right side of the DCS-900’s lens. It is located below
the Power LED.
Steady orange confirms a good connection to the LAN.
Depending on the data traffic, the LED will begin to flash to indicate that the DCS-900 is
receiving/transceiving from/to the LAN network.
Front view
Power LED
LAN LED