- D-link DCS-900 Internet Camera ManualVersion 1.10
Table Of Contents
- Table of Contents
- Package Contents
- System Requirements
- Introduction
- Features and Benefits
- Connections
- LEDs
- Hardware Installation
- Security
- Using the Setup Wizard
- DCS-900 Configuration
- IPView Lite Application Installation
- IPView Lite - Getting Started
- Uninstall IPView Application
- Appendix A: Frequently Asked Questions
- Troubleshooting
- Appendix B: How to PING your IP address
- Time Zone Table
- Xplug Control Installation
- Adjusting the Camera Focus
- Technical Specifications
- Contacting Technical Support
- Warranty and Registration
22
1) Identify Your Camera on the Network
Once you are logged into the camera via a web browser on your network PC,click
on the Advanced Tab, and select System. Enter a unique Camera Name and
Location. These settings are important if you are installing several cameras on your
network.
2) Assign a Local IP Address for Your Camera
A Local IP Address is required to configure your camera and to view your
camera within your local (home) network. You may use the default camera IP
Address of 192.168.0.20. If you wish to use a different IP Address, be sure that the
camera settings correspond to your network settings. The Default Gateway will be
the IP Address of your router’s Local IP Address(i.e.192.168.0.1 if you are using a D-
Link router)
Enter a
Unique
camera
name and
location
Identify Your Camera on Your Network
Enter a valid
IP address
for your
camera.
Assign a Local IP Address
Installing the DCS-900 Behind a Router
DCS-900 Configuration (continued)