- D-link DCS-900 Internet Camera ManualVersion 1.10
Table Of Contents
- Table of Contents
- Package Contents
- System Requirements
- Introduction
- Features and Benefits
- Connections
- LEDs
- Hardware Installation
- Security
- Using the Setup Wizard
- DCS-900 Configuration
- IPView Lite Application Installation
- IPView Lite - Getting Started
- Uninstall IPView Application
- Appendix A: Frequently Asked Questions
- Troubleshooting
- Appendix B: How to PING your IP address
- Time Zone Table
- Xplug Control Installation
- Adjusting the Camera Focus
- Technical Specifications
- Contacting Technical Support
- Warranty and Registration
14
Web Configuration
After completing the Setup Wizard, you are ready to use your camera. The web
configuration utility is designed to easily access and configure your DCS-900.
From the Web Browser, enter the IP address that you assigned to your DCS-900 to
access the Welcome screen of the DCS-900. Press Enter.
Note:
The PC’s IP address must correspond with the DCS-900’s IP address in the same
segment (i.e. PC=192.168.0.5, Camera=192.168.0.20) for the two devices to
communicate. For instructions on how to do this, please access instructions for
installing any of the D-Link Broadband Gateway products from support.dlink.com/
products.
Home Screen
After the camera’s IP address is entered in the Browser, the DCS-900 Home screen will
appear with a still image from your camera. There will be three options to choose from to
set up and view your Internet Camera:
ActiveX
Java
Setup
DCS-900 Configuration