User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration (Router Mode)
- Web-based Configuration Utility
- Setup
- IPv6
- IPv6 Manual Setup
- PLC Settings (Router Mode)
- Advanced
- Guest Zone
- IPv6 Firewall
- IPv6 Routing
- Tools
- Status
- Wireless Connection Setup Wizard
- Wireless Security Setup Wizard
- Add Wireless Device with WPS Wizard
- Configuration (AP Mode)
- Web-based Configuration Utility
- Wireless Setup Wizard
- Configuration
- Status
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Contacting Technical Support
- Warranty
- Registration
76D-Link DHP-1565 User Manual
Section 3 - Conguration
Set the transmit power of the antennas.
Beacons are packets sent by an Access Point to
synchronize a wireless network. Specify a value. 100 is
the default setting and is recommended.
This value should remain at its default setting of 2346.
If inconsistent data flow is a problem, only a minor
modication should be made.
(Delivery Trac Indication Message) 1 is the default
setting. A DTIM is a countdown informing clients of the
next window for listening to broadcast and multicast
messages.
This enables 802.11d operation. 802.11d is a wireless specication developed to allow implementation of wireless networks in
countries that cannot use the 802.11 standard. This feature should only be enabled if you are in a country that requires it.
WMM is QoS for your wireless network. This will improve the quality of video and voice applications for your wireless clients.
Transmit Power:
Beacon Period:
RTS Threshold:
DTIM Interval:
WLAN Partition:
WMM Enable:
Advanced Wireless Settings
802.11n/b/g (2.4GHz)
Check this box to reduce the guard interval time therefore increasing the data capacity. However, it’s less reliable and may create
higher data loss.
Short Guard
Interval:
Click the Save Settings button to save any changes made.