User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration (Router Mode)
- Web-based Configuration Utility
- Setup
- IPv6
- IPv6 Manual Setup
- PLC Settings (Router Mode)
- Advanced
- Guest Zone
- IPv6 Firewall
- IPv6 Routing
- Tools
- Status
- Wireless Connection Setup Wizard
- Wireless Security Setup Wizard
- Add Wireless Device with WPS Wizard
- Configuration (AP Mode)
- Web-based Configuration Utility
- Wireless Setup Wizard
- Configuration
- Status
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Contacting Technical Support
- Warranty
- Registration
138D-Link DHP-1565 User Manual
Section 4 - Security
Congure WPA/WPA2-Personal (PSK)
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish wireless connectivity before
enabling encryption. Your wireless signal may degrade when enabling encryption due to the added overhead.
1. Log into the web-based conguration by opening a web browser and entering the IP address of the router (192.168.0.1).
2. Click on Setup and then click Wireless Settings on the left side.
3. Click the Manual Wireless Connection Setup button.
4. Next to Security Mode, select WPA-Personal
5. Next to WPA Mode, select WPA/WPA2, WPA2 only or WPA only
6. Next to Cypher Type select TKIP, AES or TKIP and AES.
7. Enter the WPA network key you would like to use in the Network Key eld.
8. Click Save Settings to save your settings. If you are conguring the router with
a wireless adapter, you will lose connectivity until you enable WPA-PSK on your
adapter and enter the same passphrase as you did on the router.