User manual
34D-Link GO-RTW-N300 User Manual
Section 2 - Setting Up With a Web Browser - Router Mode
This page allows you to enable port triggering to specify inbound trac to be sent to specic ports while other ports are in
use for outbound trac.
Port Triggering
Enable or disable the Nat Port Trigger.NAT Port Trigger:
Click the Apply Changes button to save any changes made.
Select an application from the pulldown list. This will
automatically ll out the recommended settings for that
application.
Enter the name of an application.
Enter a start match port.
Enter a end match port.
Select a protocol from the pulldown menu.
Enter a start relate port.
Enter an end relate port.
Select a protocol from the pulldown menu.
Select whether it will be outgoing or incoming.
Usual Application
Name:
User-dened
Application Name:
Start Match Port:
End Match Port:
Trigger Protocol:
Start Relate Port:
End Relate Port:
Open Protocol:
Nat Type:
Click the Apply Changes button to save any changes made.
The application will then be added to the Current Portrigger Table.
Click the Delete button in the Action eld for an application type
if you wish to delete it.