Operation Manual

GO-DSL-N151 User Manual
23
The following table describes the parameters of this page:
Field Description
Username
Enter the username for PPPoE dial-up, which
is provided by your ISP.
Password
Enter the password for PPPoE dial-up, which
is provided by your ISP.
Encapsulation
You can choose PPPoE LLC, PPPoE
VC-Mux, PPPoA LLC or PPPoA VC-Mux.
Bridge Interface for
PPPoE
You can choose Activated or Deactivated.
Connection
You can choose Always On
(Recommended), Connect On-Demand or
Connect Manually.
TCP MSS Option
You can set a tcp mss value. The range is
from 100 to 1452. The default is 0.
Get IP Address You can choose Static or Dynamic.
Static IP Address
You can enter the ip address for dial-up,
which is provided by your ISP.
IP Subnet Mask
You can enter the ip subnet mask provided by
your ISP.
Gateway
You can enter the gateway ip for dial-up,
which is provided by your ISP.
NAT
Select it to enable
Network Address
Translation (NAT) function. If you do not
select it and you want to access the Internet
normally, you must add a route on the uplink
equipment. Otherwise, the access to the
Internet fails. Normally, it is enabled.
Dynamic Route You can select RIP1, RIP2-B or RIP2-M.
Direction
You can select None, Both, IN Only or OUT
Only.
TCP MTU Option
You can set a TCP MTU value. The range is
from 100 to 1500. The default is 0.
Multicast
You can choose Disabled, IGMP v1 or IGMP
v2.
MAC Spoofing You can choose Enabled or Disabled.
After finishing, click SAVE to apply the settings of this PVC.