Operation Manual

GO-DSL-N151 User Manual

Field Description

access to the Internet fails. Normally NAT is

enabled.

Default Route

You can enable or disable the default route. If

enable this function, the current PVC will be the

default gateway to internet from this device.

TCP MTU Option

You can set a tcp mtu value. The range is from

100 to 1500. The default is 0.

Dynamic Route

Select this option to specify the Routing

Information protocol (RIP) version

. You can

select RIP1, RIP2-B or RIP2-M.

Direction

You can select None, Both, IN Only or OUT

Only to specify the RIP direction. None is for

disabling the RIP function. Both means the

ADSL Router will periodically send routing

information and accept routing information then

incorporate into routing table. IN only means

the ADLS router will only accept but will not

send RIP packet. OUT only means the ADLS

router will only send but will not accept RIP

packet.

Multicast

You can choose Disabled, IGMP v1 or IGMP

v2.

Select Static IP Address in the ISP encapsulation to set static IP information.

You will need to enter in the Connection type, IP address, subnet mask, and

gateway address, provided to you by your ISP. Each IP address entered in the

fields must be in the appropriate IP form, which is four IP octets separated by a

dot (x.x.x.x). The Router will not accept the IP address if it is not in this format.