Operation Manual

GO-DSL-N151 User Manual
14
There are five WAN connection types: Auto setup by ISP list, Dynamic IP
Address, Static IP Address, PPPoE/PPPoA and Bridge Mode. Select the
appropriate wan connection type which is provided by your ISP.
For example, select the PPPoE/PPPoA, and then click NEXT, the page as shown
in the following figure appears.
The following table describes the parameters in this page:
Field Description
Username
Enter the username for PPPoE dial-up, which is
provided by your ISP.
Password
Enter the password for PPPoE dial-up, which is
provided by your ISP.
VPI
Virtual path identifier (VPI) is the virtual path
between two points in an ATM network. Its valid
value is between 0 and 255. Enter the correct VPI
provided by your ISP. By default, VPI is set to 1.
VCI
Virtual channel identifier (VCI) is the virtual
channel between two points in an ATM network.
Its valid value is between 1 and 65535. Enter the
correct VCI provided by your ISP. By default, VCI
is set to 32.
Connection Type
You can select LLC or VC-Mux. In this example,
the encapsulation mode is set to PPPoE LLC.