User's Manual
Table Of Contents
12D-Link E15 User Manual
Section 3 - Conguration
WPS-PBC Conguration
Step 1 - Initiate WPS Mode
While the Status/WPS LED is blinking orange, push the WPS button on the source
wireless router or AP, and then push the WPS button on the E15. The Status/WPS
LED will start to ash green. Please allow up to two minutes for the process to
nish. The Status/WPS LED will turn solid green when the E15 has connected
successfully to the source wireless router or access point.
Step 2 - Connecting Devices to the E15
The E15 is now ready to share the extended Wi-Fi network with your PCs
and mobile devices. You may use the WPS method to connect devices to the
extended network created by the E15 using the following network names (SSID).
The password will be the same as the wireless network you are extending.
• (Your router’s SSID)-EXT
The Smart Connect feature will present a single wireless network. When
connecting clients to the extended network, they will be automatically added to
the best band, either 2.4 GHz or 5 GHz. To disable the Smart Connect feature and
individually congure 2.4 GHz and 5 GHz SSIDs, refer to “Extender Settings” on
page 28.
Wireless Protected Setup (WPS) makes connecting your E15 easy. To use WPS, rst make sure the source router or access point
features a WPS Button or has a virtual WPS Button.