System information

75
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
IP Services Commands
set ntp update-interval
Changes how often MSS sends queries to the NTP servers for updates.
Syntax: set ntp update-interval seconds
seconds Number of seconds between queries. You can specify from 16 through 1024
seconds.
Defaults: The default NTP update interval is 64 seconds.
Access: Enabled
Examples: The following command changes the NTP update interval to 128 seconds:
DWS-1008# set ntp update-interval 128
success: change accepted.
set snmp community
Configures a community string for SNMPv1 or SNMPv2c.
Note: For SNMPv3, use the set snmp usm command to configure an SNMPv3 user. SNMPv3
does not use community strings.
Syntax: set snmp community name comm-string access {read-only | read-notify
| notify-only | read-write | notify-read-write}
comm-string Name of the SNMP community. Specify between 1 and 32 alphanumeric
characters, with no spaces.
read-only Allows an SNMP management application using the string to get (read)
object values on the switch but not to set (write) them.
read-notify Allows an SNMP management application using the string to get object
values on the switch but not to set them. The switch can use the string
to send notifications.
notify-only Allows the switch to use the string to send notifications.
read-write Allows an SNMP management application using the string to get and
set object values on the switch.
notify-read-write Allows an SNMP management application using the string to get and
set object values on the switch. The switch also can use the string to
send notifications.