System information

42
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Port Commands
Examples: The following command displays PoE information for all ports on the DWS-1008
switch:
DWS-1008# show port poe
Link Port PoE PoE
Port Name Status Type config Draw
=============================================================
1 1 up - disabled off
2 2 down - disabled off
3 3 down - disabled off
4 4 down - disabled off
5 5 down - disabled off
6 6 up MP enabled 1.44
7 7 down - disabled invalid
8 8 down - disabled invalid
The table below describes the fields in this display.
Field Description
Port Port number.
Name Port name. If the port does not have a name, the port number is listed.
Link status Link status of the port:
• up - The port is connected.
• down - The port is not connected.
Port type Port type:
• MP - The port is an AP access port.
• - (The port is not an AP access port.)
PoE config PoE state:
• enabled
• disabled
PoE Draw Power draw on the port, in watts. For 10/100 Ethernet ports on which
PoE is disabled, this field displays off. For gigabit Ethernet ports, this
field displays invalid, because PoE is not supported on gigabit Ethernet
ports. The value overcurrent indicates a PoE problem such as a short
in the cable.
show port status
Displays configuration and status information for ports.
Syntax: show port status [port-list]
port-list List of physical ports. If you do not specify a port list, information is displayed
for all ports.
Defaults: None