System information

384
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
System Log Commands
severity severity-
level
Displays messages at a severity level
greater than or equal to the level specified.
Specify one of the following:
• emergency - The switch is unusable.
• alert - Action must be taken immediately.
• critical - You must resolve the critical
conditions. If the conditions are not
resolved, the switch can reboot or shut
down.
• error - The switch is missing data or is
unable to form a connection.
• warning - A possible problem exists.
• notice - Events that potentially can cause
system problems have occurred. These
are logged for diagnostic purposes. No
action is required.
• info - Informational messages only. No
problem exists.
• debug - Output from debugging.
Defaults: None.
Access: Enabled.
Usage: The debug level produces a lot of messages, many of which can appear to be
somewhat cryptic. Debug messages are used primarily by D-link for troubleshooting and
are not intended for administrator use.
Examples: Type the following command to see the facilities for which you can view event
messages archived in the buffer:
DWS-1008# show log buffer facility ?
<facility name> Select one of: KERNEL, AAA, SYSLOGD, ACL, APM, ARP, ASO,
BOOT, CLI, CLUSTER, COPP, CRYPTO, DOT1X, ENCAP, ETHERNET, GATEWAY, HTTPD,
IGMP, IP, MISC, NOSE, NP, RAND, RESOLV, RIB, ROAM, ROGUE, SM, SNMPD, SPAN,
STORE, SYS, TAGMGR, TBRIDGE, TCPSSL, TELNET, TFTP, TLS, TUNNEL, VLAN, X509,
XML, AP, RAPDA, EAP, PORTCONFIG, FP.
The following command displays logged messages for the AAA facility:
DWS-1008# show log buffer facility AAA
AAA Jun. 25 09:11:32.579848 ERROR AAA_NOTIFY_ERR: AAA got SM special event (98)
on locality 3950 which is gone