System information

37
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Port Commands
set port type ap (continued)
Syntax: set port type ap port-list model dwl-8220ap poe {enable | disable} [radiotype
{11a | 11b | 11g}]
port-list List of physical ports.
poe enable | disable Power over Ethernet (PoE) state.
radiotype 11a |11b|11g Radio type:
• 11a—802.11a
• 11b—802.11b
• 11g—802.11g
Access: Enabled
Usage: You cannot set a port’s type if the port is a member of a port VLAN. To remove a
port from a VLAN, use the clear vlan command. To reset a port as a network port,
use the clear port type command.
When you change port type, MSS applies default settings appropriate for the port type. The
table below lists the default settings that MSS applies when you set a port’s type to ap.
Port Parameter Setting
VLAN membership Removed from all VLANs. You cannot assign an AP access
port to a VLAN. MSS automatically assigns AP access
ports to VLANs based on user traffic.
Spanning Tree Protocol (STP) Not applicable
802.1X Uses authentication parameters configured for users.
Port groups Not applicable
IGMP snooping Enabled as users are authenticated and join VLANs.
Maximum user sessions Not applicable
Examples: The following commands set port 2 for the DWL-8220AP, enable PoE on the port,
and specify external antenna model ANT-1120 for the 802.11b/g radio:
DWS-1008# set port type ap 2 model dwl-8220ap poe enable
This may affect the power applied on the configured ports. Would you like
to continue? (y/n) [n]y
success: change accepted.
DWS-1008# set dap 1 radio 1 antennatype ANT1120
success: change accepted.