System information

378
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Snoop Commands
show snoop map
Shows the AP radios that are mapped to a specific snoop filter.
Syntax: show snoop map filter-name
filter-name Name of the snoop filter.
Defaults: None.
Access: Enabled.
Usage: To display the mappings for all snoop filters, use the show snoop command.
Examples: The following command shows the mapping for snoop filter snoop1:
DWS-1008# show snoop map snoop1
filter ‘snoop1’ mapping
Dap: 3 Radio: 2
show snoop stats
Displays statistics for enabled snoop filters.
Examples: show snoop stats [filter-name [dap-num [radio {1 | 2}]]]
filter-name Name of the snoop filter.
dap dap-num Number of a Distributed AP to which the snoop
filter is mapped.
radio 1
Radio 1 of the AP.
radio 2
Radio 2 of the AP.
Defaults: None.
Access: Enabled.
Usage: The AP retains statistics for a snoop filter until the filter is changed or disabled.
The AP then clears the statistics.
Examples: The following command shows statistics for snoop filter snoop1:
DWS-1008# show snoop stats snoop1
Filter Dap Radio Rx Match Tx Match Dropped Stop-After
========================================================
snoop1 3 1 96 4 0 stopped