System information

362
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
File Management Commands
set boot partition
Specifies the boot partition in which to look for the system image file following the next
system reset, software reload, or power cycle.
Syntax: set boot partition {boot0 | boot1}
boot0
Boot partition 0.
boot1
Boot partition 1.
Defaults: By default, a switch uses the same boot partition for the next software reload
that was used to boot the currently running image.
Access: Enabled.
Usage: To determine the boot partition that was used to load the currently running
software image, use the dir command.
Examples: The following command sets the boot partition for the next software reload to
partition 1:
DWS-1008# set boot partition boot1
success: Boot partition set to boot1.
show boot
Displays the system image and configuration filenames used after the last reboot and
configured for use after the next reboot.
Syntax: show boot
Defaults: None.
Access: Access.
Examples: The following command shows the boot information for a DWS-1008 switch:
DWS-1008# show boot
Configured boot image: boot0:020003.020
Configured boot configuration: file:newconfig
Booted version: 2.0.3
Booted image: boot1:020101.020
Booted configuration: file:configuration
Product model: DWS-1008