System information

35
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Port Commands
set port poe (continued)
Defaults: PoE is disabled on network and wired authentication ports. The state on access
point ports depends on whether you enabled or disabled PoE when setting the port
type.
Access: Enabled
Examples: The following command disables PoE on ports 1 and 3, which are connected to
DWL-8220AP access points:
DWS-1008# set port poe 1,3 disable
If you are enabling power on these ports, they must be connected only to approved PoE
devices with the correct wiring. Do you wish to continue? (y/n) [n]y
The following command enables PoE on ports 2 and 4:
DWS-1008# set port poe 2,4 enable
If you are enabling power on these ports, they must be connected only to approved PoE
devices with the correct wiring. Do you wish to continue? (y/n) [n]y
set port speed
Changes the speed of a port.
Syntax: set port speed port-list {10 | 100 | 1000 | auto}
port-list List of physical ports. MSS sets the port speed on all the specified ports.
10 Sets the port speed of a 10/100 Ethernet port to 10 Mbps and sets the operating
mode to full-duplex.
100 Sets the port speed of a 10/100 Ethernet port to 100 Mbps and sets the
operating mode to full-duplex.
auto Enables a port to detect the speed and operating mode of the traffic on the link
and set itself accordingly.
Defaults: All ports are set to auto.
Access: Enabled.
Examples: The following command sets the port speed on ports 1, 3 through 6, and 8 to
10Mbps and sets the operating mode to full-duplex:
DWS-1008# set port speed 1,3-6,8 10