System information

34
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Port Commands
set port negotiation
Disables or reenables autonegotiation on gigabit Ethernet or 10/100 Ethernet ports.
Syntax: set port negotiation port-list {enable | disable}
port-list List of physical ports. MSS disables or reenables autonegotiation on all the
specified ports.
enable Enables autonegotiation on the specified ports.
disable Disables autonegotiation on the specified ports.
Defaults: Autonegotiation is enabled on all Ethernet ports by default.
Access Enabled
Usage: DWS-1008 10/100 Ethernet ports support half-duplex and full-duplex operation.
Examples: The following command disables autonegotiation on ports 1, 3, and 4 through 7:
DWS-1008# set port negotiation 1,3,4-7 disable
The following command enables autonegotiation on port 6:
DWS-1008# set port negotiation 6 enable
set port poe
Enables or disables Power over Ethernet (PoE) on ports connected to DWL-8220AP access
points.
Caution: When you set the port type for AP use, you can enable PoE on the port. Use the
switch’s PoE to power D-Link DWL-8220AP access points only. If you enable PoE on ports
connected to other devices, damage can result and the warranty will be void.
Syntax set port poe port-list enable | disable
port-list List of physical ports. MSS disables or reenables PoE on all the specified
ports.
enable Enables PoE on the specified ports.
disable Disables PoE on the specified ports.