System information

348
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
RF Detection Commands
show rfdetect vendor-list
Displays the entries in the permitted vendor list.
Syntax: show rfdetect vendor-list
Defaults: None.
Access: Enabled.
Examples: The following example shows the permitted vendor list on switch:
DWS-1008# show rfdetect vendor-list
Total number of entries: 1
OUI Type
----------------- ------
aa:bb:cc:00:00:00 client
11:22:33:00:00:00 ap
show rfdetect visible
Displays the BSSIDs discovered by a specific D-Link radio. The data includes BSSIDs
transmitted by other D-Link radios as well as by third-party access points.
Syntax: show rfdetect visible mac-addr
Syntax: show rfdetect visible ap ap-num [radio {1 | 2}]
Syntax: show rfdetect visible dap dap-num [radio {1 | 2}]
mac-addr Base MAC address of the D-Link radio.
Note: To display the base MAC address of a
D-Link radio, use the show {ap | dap} status
command.
ap-num Port connected to the access point for which to
display neighboring BSSIDs.
dap-num Number of a Distributed AP for which to display
neighboring BSSIDs.
radio 1
Shows neighbor information for radio 1.
radio 2
Shows neighbor information for radio 2. (This
option does not apply to single-radio models.)
Defaults: None.
Access: Enabled.