System information

320
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
802.1x Management Commands
Syntax: set dot1x timeout supplicant seconds
seconds Specify a value between 1 and 65,535.
Defaults: The default is 30 seconds.
Access: Enabled.
Examples: Type the following command to set the number of seconds for authentication
session timeout to 300:
DWS-1008# set dot1x timeout supplicant 300
success: dot1x supplicant timeout set to 300.
set dot1x tx-period
Sets the number of seconds that must elapse before the switch retransmits an EAPoL
packet.
Syntax: set dot1x tx-period seconds
seconds Specify a value between 1 and 65,535.
Defaults: The default is 5 seconds.
Access: Enabled.
Examples: Type the following command to set the number of seconds before the switch
retransmits an EAPoL packet to 300:
DWS-1008# set dot1x tx-period 300
success: dot1x tx-period set to 300.
set dot1x wep-rekey
Enables or disables Wired Equivalency Privacy (WEP) rekeying for broadcast and multicast
encryption keys.
Syntax: set dot1X wep-rekey {enable | disable}
enable
Causes the broadcast and multicast keys for WEP to be
rotated at an interval set by the set dot1x weprekeyperiod
for each radio, associated VLAN, and encryption type.
The DWS-1008 switch generates the new broadcast and
multicast keys and pushes the keys to the clients via EAPoL
key messages.
disable
WEP broadcast and multicast keys are never rotated.