System information

30
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Port Commands
Statistics Option Field Description
transmit-etherstats Tx 64 Number of packets transmitted that were
64 bytes long.
Tx 127 Number of packets transmitted that were
from 65 through 127 bytes long.
Tx 255 Number of packets transmitted that were
from 128 through 255 bytes long.
Tx 511 Number of packets transmitted that were
from 256 through 511 bytes long.
Tx 1023 Number of packets transmitted that were
from 512 through 1023 bytes long.
Tx 1518 Number of packets transmitted that were
from 1024 through 1518 bytes long.
reset port
Resets a port by toggling its link state and Power over Ethernet (PoE) state.
Syntax: reset port port-list
port-list List of physical ports. MSS resets all the specified ports.
Defaults: None
Access: Enabled
Usage: The reset command disables the port’s link and PoE (if applicable) for at least 1
second, then reenables them. This behavior is useful for forcing a DWL-8220AP
access point that is connected to two DWS-1008 switches to reboot over the link to
the other switch.
Examples: The following command resets port 5:
DWS-1008# reset port 5
set dap
Configures a Distributed AP for a DWL-8220AP access point that is indirectly connected to
the switch through an intermediate Layer 2 or Layer 3 network.
Note: Before configuring a Distributed AP, you must use the set system countrycode command
to set the IEEE 802.11 country-specific regulations on the switch. For an AP that is directly
connected to the switch, use the set port type ap command to configure an access port.