System information

305
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
RADIUS Commands
Usage: You can specify only one parameter per command line.
Examples: The following commands sets the dead time to 5 minutes, the RADIUS key
to goody, the number of retransmissions to 1, and the timeout to 21 seconds
on all RADIUS servers connected to the switch:
DWS-1008# set radius deadtime 5
success: change accepted.
DWS-1008# set radius key goody
success: change accepted.
DWS-1008# set radius retransmit 1
success: change accepted.
DWS-1008# set radius timeout 21
success: change accepted.
set radius client system-ip
Causes all RADIUS requests to be sourced from the IP address specified by the set system
ip-address command, providing a permanent source IP address for RADIUS packets sent
from the switch.
Syntax: set radius client system-ip
Defaults: None. If you do not use this command, RADIUS packets leaving the switch
have the source IP address of the outbound interface, which can change as
routing conditions change.
Access: Enabled.
Usage: The system IP address must be set before you use this command.
Examples: The following command sets the system IP address as the address of the
RADIUS client:
DWS-1008# set radius client system-ip
success: change accepted.
set radius proxy client
Adds a RADIUS proxy entry for a third-party AP. The proxy entry specifies the IP address of
the AP and the UDP ports on which the switch listens for RADIUS traffic from the AP.
Syntax: set radius proxy client address ip-address