System information

302
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
RADIUS Commands
DWS-1008# clear radius retransmit
success: change accepted.
DWS-1008# clear radius timeout
success: change accepted.
clear radius client system-ip
Removes the switch’s system IP address from use as the permanent source address in
RADIUS client requests from the switch to its RADIUS server(s).
Syntax: clear radius client system-ip
Defaults: None.
Access: Enabled.
Usage: The clear radius client system-ip command causes the switch to use the IP
address of the interface through which it sends a RADIUS client request as the source
IP address. The switch selects a source interface address based on information in
its routing table as the source address for RADIUS packets leaving the switch.
Examples: To clear the system IP address as the permanent source address for RADIUS
client requests, type the following command:
DWS-1008# clear radius client system-ip
success: change accepted.
clear radius proxy client
Removes a RADIUS proxy client entry for a third-party AP.
Syntax: clear radius proxy client all
Defaults: None.
Access: Enabled.
Examples: The following command clears all RADIUS proxy client entries from the switch:
DWS-1008# clear radius proxy client all
success: change accepted.
clear radius proxy port
Removes a RADIUS proxy port configured for a third-party AP.