System information

277
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Security ACL Commands
• 4 or 5 - Video. Packets are queued in DWL-8220AP forwarding
queue 2.
Use CoS level 4 or 5 for voice over IP (VoIP) packets other than
SpectraLink Voice Priority (SVP).
• 6 or 7 - Voice. Packets are queued in DWL-8220AP forwarding queue
1.
Use 6 or 7 only for VoIP phones that use SVP, not for other types of
traffic
deny Blocks traffic that matches the conditions in the ACE.
protocol IP protocol by which to filter packets:
• ip
• tcp
• udp
• icmp
• A protocol number between 0 and 255.
(For a complete list of IP protocol names and numbers, see
www.iana.org/assignments/protocol-numbers.)
source-ip-addr mask IP address and wildcard mask of the network or host from
which the packet is being sent. Specify both address
and mask in dotted decimal notation.
operator port Operand and port number(s) for matching TCP or UDP
[port2] packets to the number of the source or destination port on source-
ip-addr or destination-ip-addr. Specify one of the following operands
and the associated port:
• eq - Packets are filtered for only port number.
• gt - Packets are filtered for all ports that are greater than port
number.
• lt - Packets are filtered for all ports that are less than port number.
• neq - Packets are filtered for all ports except port number.
• range - Packets are filtered for ports in the range between port and
port2. To specify a port range, enter two port numbers. Enter the lower
port number first, followed by the higher port number.
(For a complete list of TCP and UDP port numbers, see
www.iana.org/assignments/port-numbers.)
destination-ip-addr IP address and wildcard mask of the network or host to
mask which the packet is being sent. Specify both address and
mask in dotted decimal notation.
type icmp-type Filters ICDWL-8220AP messages by type. Specify a value from 0
through 255. (For a list of ICDWL-8220AP message type and code
numbers, see www.iana.org/assignments/icmp-parameters.)