System information

273
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Security ACL Commands
Syntax: commit security acl {acl-name | all}
acl-name Name of an existing security ACL to clear. ACL names start with a
letter and are case-insensitive.
all Commits all security ACLs in the edit buffer.
Defaults: None
Access: Enabled
Usage: Use the commit security acl command to save security ACLs into, or delete them from,
the permanent configuration. Until you commit the creation or deletion of a security
ACL, it is stored in an edit buffer and is not enforced. After you commit a security ACL,
it is removed from the edit buffer.
A single commit security acl all command commits the creation and/or deletion of whatever
show security acl info all editbuffer shows to be currently stored in the edit buffer.
Examples: The following commands commit all the security ACLs in the edit buffer to the
configuration, display a summary of the committed ACLs, and show that the edit
buffer has been cleared:
DWS-1008# commit security acl all
configuration accepted
DWS-1008# show security acl
ACL table
ACL table
----------------------------------------------------------
ACL Type Class Mapping
----------------------------------------------------------
acl_123 IP Static
acl_124 IP Static
DWS-1008# show security acl info all editbuffer
acl editbuffer information for all
hit-sample-rate
Specifies the time interval, in seconds, at which the packet counter for each security ACL is
sampled for display. The counter counts the number of packets filtered by the security ACL - or
“hits.”