System information

26
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Port Commands
Port Parameter Setting
------------------------------------------------------------------------------------------------------------------------
VLAN membership None.
Note: Although the command changes a
port to a network port, the command does
not place the port in any VLAN. To use the
port in a VLAN, you must add the port to
the VLAN.
Spanning Tree Protocol (STP) Based on the VLAN(s) you add the port to.
802.1X No authorization.
Port groups None.
Internet Group Management Enabled as port is added to VLANs.
Protocol (IGMP) snooping
Access point and radio parameters Not applicable
Maximum user sessions Not applicable
Examples: The following command clears port 5:
DWS-1008# clear port type 5
This may disrupt currently authenticated users. Are you sure? (y/n) [n]y
success: change accepted.
monitor port counters
Displays and continually updates port statistics.
Syntax: monitor port counters [octets | packets | receive-errors | transmit-errors
| collisions | receive-etherstats | transmit-etherstats]
octets Displays octet statistics first.
packets Displays packet statistics first.
receive-errors Displays errors in received packets first.
transmit-errors Displays errors in transmitted packets first.
collisions Displays collision statistics first.
receive-etherstats Displays Ethernet statistics for received packets first.
transmit-etherstats Displays Ethernet statistics for transmitted packets first.