System information

214
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Access Point Commands
show {ap | dap} status
Displays DWL-8220AP access point and radio status information.
Syntax: show ap status [terse] | [port-list | all [radio {1 | 2}]]
Syntax: show dap status [terse] | [dap-num | all [radio {1 | 2}]]
terse Displays a brief line of essential status information for each DWL-8220AP.
port-list List of ports connected to the DWL-8220AP access point(s) for which to
display status.
dap-num Number of a Distributed AP for which to display status.
all Shows status information for all directly attached DWL-8220AP access points
and all Distributed AP access points configured on the switch.
radio 1 Shows status information for radio 1.
radio 2 Shows status information for radio 2. (This option does not apply to
single-radio models.)
Defaults: None.
Access: Enabled.
Note: This field applies to the display for Distributed APs only.
Examples: The following command displays the status of a Distributed AP access point:
DWS-1008# show dap status 1
Dap: 1, IP-addr: 10.2.30.5 (vlan ‘vlan-corp’), AP model: DWL-8220AP, manufacturer: D-
Link, name: AP01 fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
====================================================
State: operational
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
id=0x29c15335347f1919 ram=33554432 s/n=0333703027 hw_rev=A3
Uptime: 18 hours, 36 minutes, 27 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled] (802.11b
protect) operational channel: 1 operational power: 14 base mac: 00:0b:0e:00:d2:c0
bssid1: 00:0b:0e:00:d2:c0, ssid: public bssid2: 00:0b:0e:00:d2:c2, ssid: employee-
net bssid3: 00:0b:0e:00:d2:c4, ssid: mycorp-tkip
Radio 2 type: 802.11a, state: configure succeed [Enabled] operational
channel: 64 operational power: 14 base mac: 00:0b:0e:00:d2:c1
bssid1: 00:0b:0e:00:d2:c1, ssid: public bssid2: 00:0b:0e:00:d2:c3,
ssid: employee-net bssid3: 00:0b:0e:00:d2:c5, ssid: mycorp-tkip