System information

204
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Access Point Commands
Defaults: By default, no static WEP keys are defined.
Access: Enabled
Usage: MSS automatically enables static WEP when you define a WEP key. MSS
continues to support dynamic WEP. If you plan to use static WEP, do not map
more than 8 service profiles that contain static WEP keys to the same radio
profile.
Examples: The following command configures WEP key index 1 for service profile sp2 to
aabbccddee:
DWS-1008# set service-profile sp2 wep key-index 1 key aabbccddee
success: change accepted.
set service-profile wpa-ie
Enables the WPA information element (IE) in wireless frames. The WPA IE advertises the
WPA authentication methods and cipher suites supported by radios in the radio profile
mapped to the service profile.
Syntax: set service-profile name wpa-ie {enable | disable}
name Service profile name.
enable Enables the WPA IE.
disable Disables the WPA IE.
Defaults: The WPA IE is disabled by default.
Access: Enabled
Usage: When the WPA IE is enabled, the default authentication method is 802.1X.
There is no default cipher suite. You must enable the cipher suites you want
the radios to support.
Examples: The following command enables the WPA IE in service profile sp2:
DWS-1008# set service-profile sp2 wpa-ie enable
success: change accepted.
show {ap | dap} config
Displays global and radio-specific settings for a DWL-8220AP access point.
Syntax: show ap config [port-list [radio {1 | 2}]]
Syntax: show dap config [dap-num [radio {1 | 2}]]