System information

197
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Access Point Commands
set service-profile cipher-tkip
Disables or reenables Temporal Key Integrity Protocol (TKIP) encryption in a service
profile.
Syntax: set service-profile name cipher-tkip {enable | disable}
name Service profile name.
enable Enables TKIP encryption for WPA clients.
disable Disables TKIP encryption for WPA clients.
Defaults: When the WPA IE is enabled, TKIP encryption is enabled by default.
Access: Enabled
Usage: To use TKIP, you must also enable the WPA IE.
Examples: The following command disables TKIP encryption in service profile sp2:
DWS-1008# set service-profile sp2 cipher-tkip disable
success: change accepted.
set service-profile cipher-wep104
Enables dynamic Wired Equivalent Privacy (WEP) with 104-bit keys, in a service profile.
Syntax: set service-profile name cipher-wep104 {enable | disable}
Defaults: 104-bit WEP encryption is disabled by default.
Access: Enabled
Usage: To use 104-bit WEP with WPA clients, you must also enable the WPA IE.
When 104-bit WEP in WPA is enabled in the service profile, radios managed
by a radio profile that is mapped to the service profile can also support non-
WPA clients that use dynamic WEP.
To support WPA clients that use 40-bit dynamic WEP, you must enable WEP
with 40-bit keys. Use the set service-profile cipher-wep40 command.
Microsoft Windows XP does not support WEP with WPA. To configure a
service profile to provide dynamic WEP for XP clients, leave WPA disabled
and use the set service-profile wep commands.
To support non-WPA clients that use static WEP, you must configure static
WEP keys. Use the set service-profile wep key-index command.