System information

192
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Access Point Commands
Usage: You must disable all radios that are using a radio profile before you can
change parameters in the profile. Use the set radio-profile mode command.
Examples: The following command changes the RTS threshold for radio profile rp1 to
1500 bytes:
DWS-1008# set radio-profile rp1 rts-threshold 1500
success: change accepted.
set radio-profile service-profile
Maps a service profile to a radio profile. All radios that use the radio profile also use the
parameter settings, including SSID and encryption settings, in the service profile.
Syntax: set radio-profile name service-profile name
radio-profile Radio profile name of up to 16 alphanumeric characters, name with no
spaces.
service-profile Service profile name of up to 16 alphanumeric characters, name with
no spaces.
Defaults: A radio profile does not have a service profile associated with it by default.
In this case, the radios in the radio profile use the default settings for
parameters controlled by the service profile.
Access: Enabled
Usage: You must configure the service profile before you can map it to a radio profile.
You can map the same service profile to more than one radio profile. You
must disable all radios that use a radio profile before you can change
parameters in the profile. Use the set radio-profile mode command.
Examples: The following command maps service-profile wpa_clients to radio profile rp2:
DWS-1008# set radio-profile rp2 service-profile wpa_clients
success: change accepted.
set radio-profile short-retry
Changes the short retry threshold for the DWL-8220AP radios in a radio profile. The short
retry threshold specifies the number of times a radio can send a short unicast frame without
receiving an acknowledgment.
Syntax: set radio-profile name short-retry threshold
name Radio profile name.
threshold Number of times the radio can send the same short unicast frame. You can
enter a value from 1 through 15.