System information

184
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Access Point Commands
set radio-profile auto-tune power-backoff-timer
Sets the interval at which radios in a radio profile reduce power after temporarily increasing
the power to maintain the minimum data rate for an associated client. At the end of each
power-backoff interval, radios that temporarily increased their power reduce it by 1 dBm. The
power backoff continues in 1 dBm increments after each interval until the power returns to
expected setting.
Syntax: set radio-profile name auto-tune power-backoff-timer seconds
name Radio profile name.
seconds Number of seconds radios wait before lowering the power by 1 dBm. You can
specify from 0 to 65535 seconds.
Defaults: The default power-backoff interval is 10 seconds.
Access: Enabled.
Usage: A radio can increase power again if required to preserve the minimum data
rate for an associated client.
Examples: The following command changes the power-backoff interval for radios in radio
profile rp2 to 15 seconds:
DWS-1008# set radio-profile rp2 auto-tune power-backoff-timer 15
success: change accepted.
set radio-profile auto-tune power-config
Enables or disables dynamic power tuning (RF Auto-Tuning) for the DWL-8220AP radios in
a radio profile.
Syntax: set radio-profile name auto-tune power-config {enable | disable}
name Radio profile name.
enable Configures radios to dynamically set their power levels when the
DWL- 8220APs are started.
disable Configures radios to use their statically assigned power levels, or the default
power levels if unassigned, when the radios are started.
Defaults: Dynamic power assignment is disabled by default.
Access: Enabled
Usage: When RF Auto-Tuning for power is disabled, MSS does not dynamically set
the power levels when radios are first enabled and also does not tune power
during operation with associated clients.