System information

175
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Access Point Commands
set {ap | dap} radio channel
Sets an DWL-8220AP radio’s channel.
Syntax: set {ap port-list | dap dap-num} radio {1 | 2} channel channel-number
ap port-list List of ports connected to the DWL-8220AP access points on which to
set the channel.
dap dap-num Number of a Distributed AP on which to set the channel.
radio 1 Radio 1 of the DWL-8220AP.
radio 2 Radio 2 of the DWL-8220AP.
channel Channel number. The valid channel numbers depend on the
channel-number country of operation.
Defaults: The default channel depends on the radio type:
• The default channel number for 802.11b/g is 6.
• The default channel number for 802.11a is the lowest valid channel
number for the country of operation.
Access: Enabled
Usage: You can configure a radio’s transmit power on the same command line. Use
the tx-power option. This command is not valid if dynamic channel tuning
(RF Auto-Tuning) is enabled.
Examples: The following command configures the channel on the 802.11a radio on the
DWL-8220AP access point connected to port 5:
DWS-1008# set ap 5 radio 1 channel 36
success: change accepted.
The following command configures the channel and transmit power on the 802.11b/g radio
on the DWL-8220AP access point connected to port 2:
DWS-1008# set ap 2 radio 1 channel 1 tx-power 10
success: change accepted.
set {ap | dap} radio auto-tune min-client-rate
Sets the minimum rate at which a radio is allowed to transmit traffic to clients. The radio
automatically increases its transmit power when necessary to maintain at least the minimum
rate with an associated client.
Syntax: set {ap port-list | dap {dap-num | auto}} radio {1 | 2}
auto-tune min-client-rate rate