System information

167
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Access Point Commands
mode enabled
tx-pwr Highest setting allowed for the country of operation
radio-profile (profile) default
max-power default
min-client-rate 5.5 for 802.11b/g
24 for 802.11a
max-retransmissions 10
Examples: The following command creates a template for automatic Distributed AP
configuration:
DWS-1008# set dap auto
success: change accepted.
set dap auto mode
Enables a switch’s template for automatic Distributed AP configuration.
Syntax: set dap auto mode {enable | disable}
enable Enables the DWL-8220AP configuration template.
disable Disables the DWL-8220AP configuration template.
Defaults: The DWL-8220AP configuration template is disabled by default.
Access: Enabled
Usage: You must use the set dap auto command to create the template before you
can enable it.
Examples: The following command enables the template for automatic Distributed AP
configuration:
DWS-1008# set dap auto mode enable
success: change accepted.
set dap auto radiotype
Sets the radio type for single-DWL-8220AP radios that use the DWL-8220AP configuration
template.