System information

166
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Access Point Commands
Usage: When you enter this command, the DWL-8220AP access point drops all
sessions and reboots.
Caution: Restarting a DWL-8220AP access point can cause data loss for users who
are currently associated with the DWL-8220AP.
Examples: The following command resets the DWL-8220AP access point on port 7:
DWS-1008# reset ap 7
This will reset specified AP devices. Would you like to continue? (y/n)y
success: rebooting ap attached to port 7
set dap auto
Creates a template for automatic configuration of Distributed APs.
Syntax: set dap auto
Defaults: None
Access: Enabled
Usage: The table below lists the configurable template parameters and their defaults.
The only parameter that requires configuration is the template mode. The
template is disabled by default. To use the template to configure Distributed
DWL-8220APs, you must enable the template using the set dap auto mode
enable command.
The template uses the default radio profile by default. You can change the profile using the
set dap auto radio radio-profile command. You can use set dap auto commands to change
settings for the parameters listed in the table below.
Configurable Template Parameters for Distributed APs
DWL-8220AP Parameters
Parameter Default Value
mode disabled
bias high
upgrade-firmware enable (YES)
(boot-download-enable)
group (load balancing group) none
blink disable
(Not shown in output)
Radio Parameters
radiotype (type) 11g