System information

163
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Access Point Commands
Use DWL-8220AP access point commands to configure and manage DWL-8220AP access
points. Be sure to do the following before using the commands:
• Define the country-specific IEEE 802.11 regulations on the DWS-1008 switch.
• Install the DWL-8220AP access point and connect it to a port on the switch.
• Configure an DWL-8220AP access port (for a directly connected AP)
or a Distributed AP).
Caution: Changing the system country code after DWL-8220AP configuration disables
DWL-8220AP access points and deletes their configuration. If you change the
country code on a switch, you must reconfigure all DWL-8220AP access
points.
This chapter presents DWL-8220AP access point commands alphabetically.
clear {ap | dap} radio
Disables an DWL-8220AP radio and resets it to its factory default settings.
Syntax: clear {ap port-list | dap dap-num} radio {1 | 2 | all}
ap port-list List of ports connected to the DWL-8220AP access point(s) on which
to reset a radio.
dap Number of a Distributed AP on which to reset a radio.
dap-num
radio 1 Radio 1 of the DWL-8220AP.
radio 2 Radio 2 of the DWL-8220AP.
radio all All radios on the DWL-8220AP.
Defaults: The clear ap radio command resets the radio to the default settings.
Usage: When you clear a radio, MSS performs the following actions:
• Clears the transmit power, channel, and external antenna setting from the
radio.
• Removes the radio from its radio profile and places the radio in the
default radio profile.
This command does not affect the PoE (Power over Ethernet) setting.
Access Point Commands