System information

114
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
IP Services Commands
show timezone
Shows the time offset for the real-time clock from UTC on a DWS-1008 switch.
Syntax: show timezone
Defaults: None
Access: All
Examples: To display the offset from UTC, type the following command:
DWS-1008# show timezone
Timezone set to ‘pst’, offset from UTC is -8 hours
telnet
Opens a Telnet client session with a remote device.
Syntax: telnet {ip-addr | hostname} [port port-num]
ip-addr IP address of the remote device.
hostname Hostname of the remote device.
Defaults: MSS attempts to establish Telnet connections with TCP port 23 by default.
Access: Enabled
Usage: To end a Telnet session from the remote device, press Ctrl+t or type exit in the
management session on the remote device. To end a client session from the local
device, use the clear sessions telnet client command.
If the configuration of the switch from which you enter the telnet command has an ACL that
denies Telnet client traffic, the ACL also denies access by the telnet command.
Examples: In the following example (next page), an administrator establishes a Telnet session
with another DWS-1008 switch and enters a command on the remote switch: