System information

103
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
IP Services Commands
show ip route (continued)
NH-Type Next-hop type:
• Local - Route is for a local interface. MSS adds the
route when you configure an IP address on the switch.
• Direct - Route is for a locally attached subnet. MSS
adds the route when you add an interface in the same
subnet to the switch.
• Router - Route is for a remote destination. An switch
forwards traffic for the destination to the gateway router.
Gateway Next-hop router for reaching the route destination. Note: This field
applies only to static routes.
VLAN:Interface Destination VLAN, protocol type, and IP address of the route.
Because direct routes are for local interfaces, a destination IP
address is not listed. The destination for the IP multicast route is
MULTICAST.
For static routes, the value Down means the switch does not
have an interface to the destination’s next-hop router. To
provide an interface, configure an IP interface that is in the
same IP subnet as the next-hop router. The IP interface must
be on a VLAN containing the port that is attached to the
gateway router.
show ip telnet
Displays information about the Telnet management port.
Syntax: show ip telnet
Defaults: None
Access: All
Examples: The following command shows the status and port number for the Telnet
management interface to the switch:
DWS-1008> show ip telnet
Server Status Port
---------------------------------
Enabled 23