Installation Guide

2
D-Link DWP-1010 Quick Install Guide
ENGLISH
STEP 2: Connect an Ethernet
Cable to the PoE Port on the
DWP-1010
1. Separate the sealing cap and sealing insert
of the waterproof connector.
2. Insert the RJ-45 connector to the PoE port
by threading an Ethernet cable through
each in order: gland, sealing insert, and
sealing cap.
3. Place the water-resistant component back
to the DWP-1010.
4. Attach the sealing insert to the gland and
make sure the assembly is xed on the
bottom of the water-resistant component.
5. Attach the sealing cap and tighten until
snug.
6. Secure the water-resistant component with
the six (M2.5x6 mm) screws. Position it with
the aid of the arrow indicating the front
side on the bottom.
7. Thread the RJ-45 cable through the
protective base.
8. Reinstall the protective base with the four
(M3x4 mm) screws. (Skip this step if wall
mount will be used.)
Mounting
Mount the DWP-1010 to a Pole
Use two stainless clamps to attach the
DWP-1010 to a pole. Do not tighten
rmly until the site survey is completed.
(Refer to Connect the DWP-1010 to Your
Network and Conguration.) To adjust the
installation, loosen slightly and slide.
Mount the DWP-1010 to a Wall
Before xing the DWP-1010 onto a wall,
supply power to the device with the PoE
Injector (refer to Connect the DWP-1010 to
Your Network) and check the signal strength
using the LED indicators (refer to Signal
Strength).
1. Mark the mounting positions with a pencil
following the above alignment guide.
2. Drill holes on the wall no wider than the
anchor.
3. Hammer in the anchors until they are ush
with the wall.
4. Align the protective base over the holes
and secure it tightly with screws.
5. Reassemble the body of the DWP-1010
and the base. Secure them with the four
(M3x4 mm) screws.
Sealing Insert
Sealing Cap
Gland
RJ-45