User's Manual Part 2

5. Using the Configuration Menu

The Configuration Menu for the DWL-700AP is web-based. When using

the configuration program, please consider the following:

Factory Default Settings for the DWL-700AP

SSID

Channel

Encryption

disabled

User Name

admin

Password

(no password, leave field blank)

IP Address

192.168.0.50

You will need a JavaScript-enabled web-browser such as Internet Explorer

4.0 or higher, or Netscape Navigator 4.0 or higher.

The computer that you are using for initial configuration must have an IP

Address within the same range as the IP Address of the DWL-700AP.

The DWL-700AP has a default IP Address of 192.168.0.50 with subnet

mask of 255.255.255.0

If you are using a D-Link router in your network, such as the DI-604, with the

factory default settings, you will not need to assign a static IP Address to the

computer that you are using to configure the Access Point. (Skip to Fig. 5.1:

entering the IP address)

If you are not using a D-Link router in your network, you will need to assign a

Static IP Address to the computer that you are using to configure the DWL-

700AP, with in the IP Address Range of the DWL-900AP+. Assign a static IP

address of 192.168.0.2 with subnet mask of 255.255.255.0 (Please see

Networking Basics in this manual for information on Assigning a Static IP

Address.) Note: Please write down the current IP address settings of the

computer. You may need to revert back to these settings after configuring the

DWL-900AP+.

After you have assigned a Static IP Address to the computer you are using for

configuration (if necessary), next you will assign the

DWL-7000AP

an IP

Address within the range of your existing network.

After changing the IP Address of the DWL-700AP you will need to enter the

IP into the address bar of your web browser to access the configuration page

of the DWL-700AP

If the computer had a static IP address, re-input that same address.

If the computer had a dynamic IP Address (i.e., a DHCP capable router

automatically assigns the IP Address) then change the setting of your

network adapter to receive a Dynamic IP Address.

default