User's Manual Part 4

Using the Configuration Menu (continued)

Repeater: This mode will allow

you to extend the range of your

wireless network. The repeater

mode will work with another

D-Link AirPlus DWL-700AP,

DWL-900+, DI-614+, DI-714P+,

AirPro DI-764, DI-754 (with

inserted DWL-650+), or AirPremier

DWL-1

000

AP+.

Note! If you use the DWL-700AP

in Wireless Client or Repeater

Mode, make sure that you enter the

Ethernet Mac Address (LAN MAC

ddress) of the unit that you want to

extend the wireless coverage.

Note: The repeater function is

available with at least firmware

version 2.20 or above. For the latest

drivers and firmware downloads,

please go to www.support.dlink.com

DWL-700AP

DI-614+

PAGE 1
Using the Configuration Menu (continued) Note: The repeater function is available with at least firmware version 2.20 or above. For the latest drivers and firmware downloads, please go to www.support.dlink.com. Repeater: This mode will allow you to extend the range of your wireless network. The repeater mode will work with another D-Link AirPlus DWL-700AP, DWL-900+, DI-614+, DI-714P+, AirPro DI-764, DI-754 (with inserted DWL-650+), or AirPremier DWL-1000AP+.
PAGE 2
Using the Configuration Menu (continued) The default Performance settings are shown here. Advanced > Performance Beacon Interval: Beacons are packets sent by an Access Point to synchronize a wireless network. Specify a Beacon interval value. Default (100) is recommended. RTS Threshold: This value should remain at its default setting of 2,432. If you encounter inconsistent data flow, only minor modifications to the value range between 256 and 2,432 are recommended.