Installation guide

• Double-click on Network

Adapters

• Right-click on D-Link

AirPro DWL-A650

Wireless Cardbus

Adapter

• Select Properties to

check that the drivers are

installed properly

 Check that the Ethernet LED on the DWL-G700AP is ON. If the LED

is not ON, check that the cable for the Ethernet connection is securely

inserted.

 Check that the Ethernet adapter is working properly. Please see item

3 (Check that the drivers for the network adapters are installed

properly) in this Troubleshooting section to check that the drivers

are loaded properly.

 Check that the IP address is in the same range and subnet as the

DWL-G700AP. Please see Checking the IP Address in Windows XP

in the Networking Basics section of this manual.

 Do a Ping test to make sure that the DWL-G700AP is responding. Go

to Start>Run>Type Command>Type ping 192.168.0.50. A successful

ping will show four replies.

Note: It is recommended that you use an Ethernet connection to congure the

DWL-G700AP Access Point.

1. The computer used to congure the DWL-G700AP cannot access the

conguration menu.

Note: The IP address of the DWL-G700AP is 192.168.0.50. All the computers on

the network must have a unique IP address in the same range, e.g., 192.168.0.x.

Any computers that have identical IP addresses will not be visible on the network.

They must all have the same subnet mask, e.g., 255.255.255.0

Troubleshooting

This chapter provides solutions to problems that can occur during the installation and

operation of the DWL-G700AP. We cover various aspects of the network including

network adapters. (The examples below are illustrated in Windows XP. If you have

another operating system, these solutions will still apply, although the appearance on

your computer screen may differ.)