Datasheet

05
DWL-8600AP
Wireless Unified 802.11n Access Point
Stand-Alone Mode Managed Mode
(Managed by DWS-4026 switch)
Centralized Management -
Centralized Firmware Dispatch -
Visualized AP Management Tool -
Auto-Power Adjustment -
Dynamic Auto-Channel Selection -
L2 Fast Roaming -
L3 Fast Roaming -
Captive Portal -
WEP/WPA/WPA2 Security
Rogue AP Detection
Rogue AP Mitigation -
WIDS -
Station Isolation
MAC Address Filtering
AP Load Balancing Setup
WDS
-
AP Clustering
-
QoS/WMM
Local Storage of Configuration
-
1
Maximum wireless signal rate 300Mbps and 54Mbps is based on IEEE 802.11n and 802.11a/g specifications, respectively. Actual
data throughput will vary. Network conditions and environmental factors, including volume of network traffic, building materials and
construction, and network overhead can lower actual data throughput rate.
2
MCS Index: The Modulation and Coding Scheme (MCS) index determines the number of spatial streams, the modulation, the coding
rate, and data rate values. MCS Index is only available for 802.11n standard.
3
GI: A Guard Interval (GI) between symbols helps receivers overcome the effects of multipath delays. A GI of 400ns is also called
Short Guard Interval (SGI).
4
Maximum power setting will vary according to individual country regulations.
Specifications subject to change without prior notice.
D-Link is a registered trademark and of D-Link Corporation and its overseas subsidiaries.
All other trademarks belong to their proprietors.
Release 01 (November 2009)
ACN 052 202 838
I
D-Link Corporation
No. 289 Xinhu 3rd Road, Neihu, Taipei 114, Taiwan