User`s manual
3
DWS-1008 User’s Manual
D-Link Systems, Inc.
Hardware Overview
Hardware Overview (Front Panel)
Console Port:
The serial console port provides a direct management connection to a DWS-1008 switch’s
command-line interface (CLI). The port has a DB-9 female connector and supports the
EIA-232D signaling standard.
Ethernet Ports (1-6):
The 10/100 Ethernet ports on the DWS-1008 switch provide automatic MDI/MDX, which
automatically crosses over the send and receive signals if required. Ports 1-6 support PoE.
Uplink Ports (7 & 8):
Ports 7 and 8 on the DWS-1008 switch are uplink ports only and do not support PoE.
LEDS:
Link (1-8):
Solid green 100Mbps link is operational.
Solid amber 10Mbps link is operational.
Blinking green Trafc is active on the 100Mbps link.
Blinking amber Trafc is active on the 10Mbps link.
AP (1-6):
Solid green For an DWL-8220AP’s active link, with PoE enabled, all the following
are true:
• Access point has booted.
• Access point has received a valid conguration from the switch.
• Management link with an access point is operational.
Alternating green Access point is booting with an image received from the switch.
and amber If the LED remains in this state indenitely, the boot or conguration
attempt has failed.
Solid amber PoE is on but no access point is connected to the link.
Blinking amber Access point is not connected or is unresponsive, or there is a PoE
problem.
Unlit Port is not congured as an AP access port, or PoE is off.