User`s manual

68
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring and Managing Ports and VLANs
Resetting a Port
You can reset a port by toggling its link state and PoE state. MSS disables the port’s link and
PoE (if applicable) for at least one second, then reenables them.
This feature is useful for forcing a DWL-8220 access point that is connected to two
DWS-1008 switches to reboot using the port connected to the other switch.
To reset a port, use the following command:
reset port port-list
Displaying Port Information
You can use CLI commands to display the following port information:
• Port conguration and status
• PoE state
• Port statistics
You also can congure MSS to display and regularly update port statistics in a separate window.
Displaying Port Conguration and Status
To display port conguration and status information, use the following command:
show port status [port-list]
To display information for all ports, type the following command:
Note: PoE is supported only on 10/100 Ethernet ports. PoE is not supported on ports 7 and
8.
DWS-1008# show port status
Port Name Admin Oper Config Actual Type Media
========================================================
1 1 up up auto 100/full network 10/100BaseTx
2 2 up down auto network 10/100BaseTx
3 3 up down auto network 10/100BaseTx
4 4 up down auto network 10/100BaseTx
5 5 up down auto network 10/100BaseTx
6 6 up up auto 100/full network 10/100BaseTx
7 7 up down auto network 10/100BaseTx
8 8 up down auto network 10/100BaseTx
In this example, two of the switch’s ports, 1 and 6, have an operational status of up, indicating
the links on the ports are available.