User`s manual
40
DWS-1008 User’s Manual
D-Link Systems, Inc.
Configuration (continued)
Conguration
The following command congures radio prole rp1:
DWS-1008# set radio-prole rp1
success: change accepted.
The table below lists the radio prole parameters and their default values.
Parameter Default Value Radio Behavior When Parameter Set To Default Values
11g-only disable Allows associations with802.11g and 802.11b
clients. This parameter applies only to 802.11b/g
radios.
active-scan enable Sends probe any requests (probe requests with a
null SSID name) to solicit probe responses from
other access points.
beacon-interval 100 Waits 100 ms between beacons.
countermeasures Not congured Does not issue countermeasures against any
device.
dtim-interval 1 Sends the delivery trafc indication map (DTIM)
after every beacon.
frag-threshold 2346 Transmits frames up to 2346 bytes long without
fragmentation.
long-retry 5 Sends a long unicast frame up to ve times
without acknowledgment.
max-rx-lifetime 2000 Allows a received frame to stay in the buffer for up
to 2000 ms (2 seconds).
max-tx-lifetime 2000 Allows a frame that is scheduled for transmission
to stay in the buffer for up to 2000 ms (2 seconds).
preamble-length short Advertises support for short 802.11b preambles,
accepts either short or long 802.11b preambles,
and generates unicast frames with the preamble
length specied by the client.
rts-threshold 2346 Transmits frames longer than 2346 bytes by means
of the Request-to-Send/Clear-to-Send (RTS/CTS)
method.