User`s manual

36
DWS-1008 User’s Manual
D-Link Systems, Inc.
Configuration (continued)
Conguration
Congure the same Distributed AP on each of the switches you want to use to manage the AP
access point associated with the Distributed AP. Make sure to use the same Distributed AP
number and serial ID on each switch. To display conguration information for all Distributed
APs congured in the MobileLAN, use the following command:
show dap global [dap-num | serial-id serial-ID]
The following command lists conguration information for the Distributed APs below:
DWS-1008# show dap global
Total number of entries: 12
DAP Serial Id Switch IP Address Bias
------ ----------------- ------------------------- ------
1 0322199999 10.10.10.4 HIGH
- 0322199999 10.10.40.4 HIGH
- 0322199999 10.10.50.4 HIGH
2 0322199998 10.10.10.4 HIGH
- 0322199998 10.10.40.4 HIGH
- 0322199998 10.10.50.4 HIGH
- 0322199997 10.10.40.4 HIGH
- 0322199997 10.10.50.4 HIGH
- 0322199996 10.10.40.4 HIGH
- 0322199996 10.10.50.4 HIGH
- 0322199995 10.10.40.4 HIGH
- 0322199995 10.10.50.4 HIGH
This example assumes that each switch is congured with a Distributed AP connection
(DAP) for each AP that is not directly connected to the switch. The APs that are directly
connected to 10.10.10.4 (switch1) are not congured as Distributed APs on switch1, but they
are congured as Distributed APs on the other switches. On Switch1, the directly connected
APs are congured using AP access ports, with the set port type ap command.
A DAP number is listed only for Distributed APs that are congured on the switch on which
you type the command. For Distributed APs congured on other switches, a hyphen ( - )
is displayed in the DAP eld. The bias determines the switch a Distributed AP prefers for
booting, conguration, and data transfer.