User`s manual

33
DWS-1008 User’s Manual
D-Link Systems, Inc.
Configuration (continued)
Conguration
Conguring for a Directly-Connected AP
Caution: When you set the port type for use by locally connected APs, you must specify the
PoE state (enabled or disabled) of the port. If you enable PoE on a port connected to another
device, physical damage to the device can result.
To set a port for a locally-connected AP, use the following command:
set port type ap port-list
model {DWL-8220AP}
poe {enable | disable}
[radiotype {11a | 11b| 11g}]
You must specify a port list of one or more port numbers, the AP model number, and the PoE
state.
DWL-8220AP access points have a two radios; One radio is always 802.11a. The other
radio is 802.11b/g, but can be congured for 802.11b or 802.11g exclusively. If the country
of operation specied by the set system countrycode command does not allow 802.11g, the
default is 802.11b.
DWL-8220AP radios congured for 802.11g also allow associations from 802.11b clients
by default. To disable support for 802.11b associations, use the set radio-prole 11g-only
command on the radio prole that contains the radio.
The DWL-8220AP has an internal 802.1b/g antenna as well as a connector for an external
antenna, so use of an external antenna is optional on these models. It also has a connector
for an optional external 802.11a antenna. To specify the antenna model, use the set {ap |
dap} radio antennatype command.
To verify the conguration changes, use the following commands. Use show ap config for
directly connected APs and use show dap config for Distributed APs.
show ap config [port-list [radio {1 | 2}]]
show dap config [dap-num [radio {1 | 2}]]