User`s manual

326
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring Communication with RADIUS
For example, to delete the server group shorebirds, type the following command:
DWS-1008# clear server group shorebirds
success: change accepted.
The members of the group remain congured, although no server groups are shown:
DWS-1008# show aaa
Default Values
authport=1812 acctport=1813 timeout=5 acct-timeout=5
retrans=3 deadtime=0 key=(null) author-pass=(null)
Radius Servers
Server Addr Ports T/o Tries Dead State
-------------------------------------------------------------------------------------------
sandpiper 192.168.253.3 1812 1813 5 3 0 UP
heron 192.168.253.1 1812 1813 5 3 0 UP
coot 192.168.253.4 1812 1813 5 3 0 UP
egret 192.168.253.2 1812 1813 5 3 0 UP
Server groups
RADIUS and Server Group Conguration Scenario
The following example illustrates how to declare four RADIUS servers to an switch and
congure them into two load-balancing server groups, swampbirds and shorebirds:
1. Congure RADIUS servers. Type the following commands:
DWS-1008# set radius server pelican address 192.168.253.11 key elm
DWS-1008# set radius server seagull address 192.168.243.12 key r
DWS-1008# set radius server egret address 192.168.243.15 key pine
DWS-1008# set radius server sandpiper address 192.168.253.17 key oak
2. Place two of the RADIUS servers into a server group called swampbirds. Type the following
command:
DWS-1008# set server group swampbirds members pelican seagull
3. Enable load balancing for swampbirds. Type the following command:
DWS-1008# set server group swampbirds load-balance enable
4. Place the other RADIUS servers in a server group called shorebirds. Type the following
command:
DWS-1008# set server group shorebirds members egret pelican sandpiper
5. Enable load balancing for shorebirds. Type the following command:
DWS-1008# set server group shorebirds load-balance enable