User`s manual

17
DWS-1008 User’s Manual
D-Link Systems, Inc.
Configuration (continued)
Conguration
Accessing the CLI
To enter the conguration commands in this section, you must log in to the enabled access
level of the CLI. The default username and password are null strings.
To log in from the serial console to the enabled access level for conguration:
1. Press Enter to display a username prompt.
Username:
2. Press Enter again to display a password prompt.
Username:
Password:
3. Press Enter a third time to display a command prompt.
Username:
Password:
DWS-1008>
Note: For simplicity, the command prompt examples in the documentation show a switch
model (such as DWS-1008) and the CLI access level (> for restricted access or # for enabled
access) only. The default command prompt on your switch shows your switch’s model
number and also contains the last three octets of the switch’s MAC address. For example, the
default command prompt on an DWS-1008 switch with MAC address 00:0B:0E:00:04:0A is
DWS-1008-00040A>.
4. Type the enable command and press Enter once more to display the prompt for the
enabled access level.
Username:
Password:
DWS-1008> enable
DWS-1008#