User`s manual

205
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring RF Auto-Tuning
Displaying RF AutoTuning Information
You can display the RF AutoTuning conguration, a list of RF neighbors, and the values of
RF attributes.
Displaying RF AutoTuning Settings
To display the RF AutoTuning settings that you can congure in a radio prole, use the
following command:
show radio-prole {name | ?}
Entering show radio-prole ? displays a list of radio proles.
To display the RF AutoTuning and other settings in the default radio prole, type the following
command:
DWS-1008# show radio-prole default
Beacon Interval: 100 DTIM Interval: 1
Max Tx Lifetime: 2000 Max Rx Lifetime: 2000
RTS Threshold: 2346 Frag Threshold: 2346
Short Retry Limit: 5 Long Retry Limit: 5
Long Preamble: no Allow 802.11g clients only: no
Tune Channel: yes Tune Power: no
Tune Channel Interval: 3600 Tune Power Interval: 600
Power Backoff Timer: 10 Channel Holddown: 300
Countermeasures: none Active-Scan: yes
WMM enabled: yes
Service profiles: default-dot1x, default-clear
To display the RF AutoTuning settings that you can congure on an individual radio, use the
following commands:
show ap cong [port-list [radio {1 | 2}]]
show dap cong [dap-num [radio {1 | 2}]]
To display the RF AutoTuning and other individual radio settings on radio 1 of a directly
connected AP access port connected to port 2, type the following command:
DWS-1008# show ap cong 2 radio 1
Port 2: AP model: DWL-8220AP, POE: enable, bias: high, name: AP02
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: disabled, channel: 6
tx pwr: 1, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10